G-Code INCOG vs. INCOG Eclipse (makeshift version – Super mojo riser on original INCOG)

This is actually a comparison of the original INCOG holster vs. a makeshift version of the INCOG Eclipse (using the Super MOJO riser on the original INCOG holster).

I’d like to still have the choice to add the magazine caddy, so I ended up not purchasing the new INCOG Eclispe holster (cannot attach mag caddy), but instead, I got myself a Super Mojo riser to put on the original INCOG, thereby trying out the clip position of the INCOG Eclipse. It is essentially an Eclipse, plus a little material (next to the front sight).

DSC08327

The Super Mojo riser on the original INCOG holster. Its basically the Eclipse with extra material next to where the front sight would be. 

The main difference between the INCOG and the INCOG Eclipse is the position of the clip.

  • The original INCOG holster was designed to have two clips to the side, even though many people prefer to only use one clip.
  • The INCOG Eclipse holster was designed to use one clip at the center of the holster, along the slide.
(left) Super Mojo riser on original Incog. (right) Original Mojo riser on Incog.

(left) Super Mojo riser on original INCOG. (right) Original Mojo riser on INCOG.

After trying it out, I still prefer the original INCOG, and below I’ll detail why I prefer the original, but other people may prefer the Eclipse due to their position of carry and body type.

Overview

The Original INCOG

The INCOG holster was designed to be very versatile. It could either be carried with 1 or 2 clips, or use in combination with the magazine carrier. It also has adjustable height, cant, and retention.

The 2-clips configuration is definitely more sturdy, and there will be no shifts to where the gun will be throughout the day. However, the 1-clip configuration gives is easier to put on and off, and allows a little angle shift if you sit a lot during the day.

Read this post for a detailed review of the original INCOG holster (and comparison to the Phlster Access holster).

The original Incog with Smith & Wesson Shield.

The original INCOG with Smith & Wesson Shield.

Carrying with the original INCOG

Carrying the INCOG around 2:00.

INCOG -makeshift- “Eclipse” (self-mod by adding Super Mojo on original INCOG)

Overall, the INCOG -makeshift- “Eclipse” was just as easy to carry as the original INCOG. If you order the actual Eclipse holster, it will still have adjustable height, cant and retention. The actual Eclipse holster won’t have the ‘tab’ near the front sight of the gun, which is where the magazine caddy would attach to the original INCOG.

Some online reviews have expressed concern as to how the position of the clip may interfere with ‘indexing’ your finger while drawing. I don’t find that to be an issue. It is essentially the same as drawing from any holster with a center clip. The bottom line is, if I could obtain a firm and proper grip while drawing, my index finger will land where it should be after I draw (i.e., next to the slide, above the trigger).

Incog -makeshift-

INCOG -makeshift- “Eclipse” with the Smith & Wesson Shield.

Carrying the eclipse.

Carrying the INOCG with Super MOJO riser. Notice the clip is closer to the center of the gun.

The difference between the two:

  1. Thickness

    • Because the clip of the Eclipse is at the center of the holster, the overall thickness of the holster increases by quite a bit (see pics of measurement below). The difference is about 2cm (~0.8 inch) before compression. So the difference is probably about 1-1.5cm when it is actually inside the waistband and the clip is slightly pushed towards the body.
    • measurements

      The original INCOG at its thickest is 46mm vs. 64mm when using the Super Mojo riser, which is what the Eclipse would be.

  2. Force on the grip

    • The G-code INCOG clips have an angle (and some springy-ness) to it, which aids in pushing the grip of the gun into the body. Since the Eclipse has the clip closer to the center, the force of the clip is applied equally across the grip, whereas 1-clip on the original INCOG (clip on the grip side) pushes the end of the grip into the body. I find that pushing the end of the grip aids concealing more than the whole gun. Equal force pushing on the whole grip leaves the corner of the grip more likely to print (a little) through clothing.

Conclusion

As I prefaced in the beginning of the post, I’m sticking with the original INCOG, and its because of:

  • thickness difference
  • I prefer the force of the clip pushing mainly into the grip.
  • BONUS: I prefer the capability to add a magazine caddy, which is one of the main reason I wanted the INCOG holster to begin with.

Would I consider the Eclipse if I didn’t already have the original INCOG, and I’m looking just for a single holster that doesn’t need the capability of an attached magazine? Yes.

  • Yes, because it is still a very versatile holster due to the adjust-ability (i.e., height, cant, retention) and quality of G-code. If there is no need to attach a mag-caddy, the fact that it has no extra material sticking out from the side (i.e., the part use to attach the mag caddy) is an advantage over the original INCOG as well.

Importantly, my preference is based on how I carry and my body type.

  • I carry more around 2:00, and I actually prefer the 1-clip on the INCOG pushing the grip into my body. If somebody carries around 1:00 appendix, the Eclipse might actually work better because it will exert force on the whole gun (across the slide and grip), pushing the entire gun into the body and aiding concealment. So, if unsure whether the Eclipse is suitable for your need, just buy the Super Mojo and give it a try. If you don’t like it, you can easily sell it on ebay or other forums.
Advertisements

2 thoughts on “G-Code INCOG vs. INCOG Eclipse (makeshift version – Super mojo riser on original INCOG)

  1. Pingback: [Review] IWB Holsters, the HSP INCOG vs. PHLster ACCESS | Explore, Expose, and Experience

  2. Pingback: [Review] IWB Holsters, the HSP INCOG vs. PHLster ACCESS | EXPX3

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s